Leak Detection in Lithonia, Georgia

Yes. We connect Lithonia property owners and homeowners in DeKalb County with licensed leak detection specialists. Our network covers all of Georgia and is available for water leak detection, slab leak detection, underground pipe detection, hidden leak investigation, and emergency leak response. Call (844) 485-0339 to speak with a dispatcher who can connect you with an available specialist in your area.

Slab leak signs in Lithonia include warm or wet spots on concrete floors, a running water meter with all fixtures off, unusually high water bills, and foundation cracks appearing without an obvious cause. Clay soil movement in DeKalb County stresses buried copper lines over time, making slab leaks more common in older slab-on-grade construction. Professional leak detection can confirm or rule out a slab leak without breaking your floor.

Professional slab leak detection typically costs $150–$400 for the detection service alone, separate from any repair work. Acoustic electronic detection — the most common method — falls in the $150–$300 range. Tracer gas detection, used when acoustic signals are weak (such as under thick concrete or with PEX pipe), typically runs $250–$400. The detection fee covers locating and marking the leak position to within a few inches, which directly reduces repair excavation costs. Detection cost is a small fraction of total project cost — avoiding unnecessary concrete cutting by knowing the exact leak location typically saves $500–$2,000 in repair labor.

Summer creates several distinct leak drivers that make July and August peak months for certain leak types: (1) Peak water demand — irrigation, pools, and increased usage push system pressure to seasonal highs that stress aging pipe fittings; (2) Soil desiccation — in clay soil regions, summer drought causes maximum shrinkage, creating soil movement that stresses slab-embedded and buried pipes; (3) Thermal expansion — copper supply lines experience their maximum annual thermal expansion in summer, stressing joints; (4) Irrigation system activation — irrigation systems that have been off all winter often reveal cracked heads, failed zone valves, and failed backflow preventers when restarted in spring/summer; (5) Pool and outdoor plumbing use — outdoor plumbing that is inactive in winter begins operating again, and winter-damaged fittings fail under pressure.

Yes — and this is the primary reason early detection matters. A pressurized supply line leak under a slab introduces water into the sub-slab soil at a continuous rate. In expansive clay soils, this causes localized soil swelling that can heave the slab unevenly. In sandy or silty soils, it can cause subsidence — the opposite problem, where the soil washes away and the slab loses support. Either scenario produces differential foundation movement, which manifests as sticking doors, diagonal wall cracks, and sloping floors. Foundation damage from an undetected slab leak is typically not covered by standard homeowners insurance as it is classified as ongoing neglect rather than a sudden event.

Private service line failures (the homeowner's underground water line) are caused by: (1) pipe material age — galvanized steel and lead service lines installed in homes before 1960 are past designed service life; (2) soil movement — freeze-thaw cycling and expansive clay movement stress pipe joints repeatedly until failure; (3) tree root intrusion — roots follow moisture and can encircle and crush or pierce service lines, particularly older clay or galvanized lines; (4) external loading — heavy vehicles driving over a shallow-buried service line, or settlement of pavement above it; (5) electrolytic corrosion — stray electrical currents in the soil accelerate corrosion of metallic pipes. Plastic pipes (PVC, PEX) are significantly more resistant to all of these failure modes than older metallic pipe materials.

A moving meter with no visible leak almost always means the leak is hidden — either inside walls, under the slab, underground between the meter and the house, or in an irrigation system branch. The most common locations for hidden leaks detected this way are: (1) slab supply lines under the concrete floor; (2) underground service line between the meter and the house foundation; (3) toilet flappers (though these are more commonly caught by dye testing than meter observation); (4) outdoor irrigation zone valves that fail to close fully. The next diagnostic step is to isolate the leak to a specific zone by closing the main shutoff valve inside the house and observing whether the meter continues to move — if it does, the leak is between the meter and the house on the service line.

Responsibility is typically split at the water meter, which sits at or near the property line. The municipal water utility owns and maintains everything from the water main in the street to the meter. The homeowner owns and is responsible for everything from the meter to the house — including the full underground service line run across the property. This is an important distinction because service line leaks on the homeowner's side are the homeowner's financial responsibility, and standard homeowners insurance (HO-3 policies) does not cover underground service line repair by default. A service line insurance endorsement — available from most insurers for $30–$60 per year — extends coverage to this exposure. Some utilities have begun offering service line protection programs as a billing add-on.

The timing depends on your primary risk profile. For freeze-risk regions (Midwest, Northeast, Mountain): late fall (October–November) before the first hard freeze is ideal for identifying vulnerable pipe sections before they are stressed. For clay soil regions (Texas, Oklahoma, Kansas, Alabama): late summer or early fall, after peak soil desiccation has maximized stress on slab pipes. For irrigation-heavy regions: early spring before irrigation systems are activated, when damaged components from the previous season can be identified before they cause water loss all summer. For all regions: the best practical answer is as soon as you notice any indicator — water bill increase, discolored water, running water sounds, unexplained moisture. Waiting for a 'good time' often means waiting until the leak has grown.

Tree roots are a primary cause of sewer and drain line failure but rarely breach pressurized supply lines directly. The mechanism differs by line type: For drain and sewer lines — roots seek moisture and enter through pipe joints, cracks, or defects in clay tile, cast iron, concrete, or Orangeburg pipe. Once inside, they grow to fill the pipe diameter. For supply lines — roots can encircle and compress older metallic pipes over decades, causing deformation at joints. They can also cause joint separation through root growth pressure, particularly in older galvanized or lead pipe systems. For irrigation lines — roots seeking moisture are a common cause of drip emitter failure and shallow poly pipe breaches. The tree root risk radius is approximately equal to the tree's drip line (the canopy edge) for actively growing roots, but larger established root systems may extend 2–3× the drip line.