Leak Detection in Dickinson, North Dakota

Yes. We connect Dickinson property owners and homeowners in Stark County with licensed leak detection specialists. Our network covers all of North Dakota and is available for water leak detection, slab leak detection, underground pipe detection, hidden leak investigation, and emergency leak response. Call (844) 485-0339 to speak with a dispatcher who can connect you with an available specialist in your area.

In Dickinson, pipes in unheated spaces — crawlspaces, garages, exterior walls — are most vulnerable during hard freezes. A pipe that freezes may not burst immediately; freeze-thaw cycling creates micro-fractures that fail days or weeks later. If you experienced a freeze event and notice reduced pressure or unexplained moisture in Stark County, professional leak detection can find damage before it becomes a larger structural problem.

Pipe freeze prevention depends on your home's construction type and local frost depth. For all homes: (1) Know where your main shutoff valve is and confirm it operates before winter; (2) Disconnect and drain garden hoses from exterior hose bibs — a connected hose traps water in the spigot and can freeze back into the supply line; (3) Insulate pipes in unheated spaces — garages, crawlspaces, and unconditioned attics. For homes in regions with frost depths below 15 inches (most of the South): (4) Let faucets drip slightly during freeze events — moving water is harder to freeze; (5) Open cabinet doors under sinks on exterior walls to allow heated room air to reach the pipes. For crawlspace homes: (6) Seal crawlspace vents before first freeze to trap ground warmth. For vacant properties: (7) Maintain minimum 55°F interior temperature or fully drain and blow out the supply system with compressed air.

Yes — and this is a frequently overlooked risk. An in-ground pool that develops a structural leak can introduce hundreds of gallons per day into the surrounding soil. In expansive clay soils, this causes chronic soil saturation that keeps the clay in a swollen state — which can destabilize adjacent foundation footings and slabs. In sandy or permeable soils, continuous pool leak flow can wash soil away from beneath adjacent structures, causing settlement. Pool leaks typically go undiagnosed because pool owners attribute water loss to evaporation — but evaporation rarely exceeds 1/4 inch per day, while pool leaks can exceed 1 inch per day. The bucket test (floating a bucket of water in the pool for 24 hours and comparing the drop in pool level to the drop in bucket level) is the standard homeowner self-test for pool leak identification.

Polybutylene pipe is identifiable by its gray, blue, or black color — gray is most common for interior supply lines. Look under sinks, behind the water heater, and at the point where pipes enter walls. The pipe is typically 1/2 inch or 3/4 inch diameter with a dull, matte surface. Fittings are usually gray or white plastic (acetal) or aluminum. If your home was built between 1978 and 1995 and you see gray plastic supply lines, it is almost certainly polybutylene. You can also check the pipe labeling — polybutylene is often stamped 'PB2110'. If confirmed, consult with a licensed plumber about your replacement options — polybutylene was the subject of a class action settlement (Cox v. Shell Oil) specifically because of its documented failure rate.

Orangeburg pipe (also called bituminous fiber pipe) is a drain and sewer pipe made from layers of wood pulp and pitch, manufactured from the 1860s through the 1970s. It was widely used as drain and sewer pipe in homes built before 1970 because it was inexpensive and easy to cut. The problem: Orangeburg was designed with an expected service life of 50 years, and that life is now long expired. It absorbs moisture over time, which causes it to deform from a round cross-section to an oval or collapsed shape. Once deformed, it can no longer carry sewage effectively, and complete collapse follows. Homes built before 1970 — particularly in the Northeast and Midwest — have a high probability of having Orangeburg sewer laterals. A sewer camera inspection is the definitive test.

Yes — and this is the primary reason early detection matters. A pressurized supply line leak under a slab introduces water into the sub-slab soil at a continuous rate. In expansive clay soils, this causes localized soil swelling that can heave the slab unevenly. In sandy or silty soils, it can cause subsidence — the opposite problem, where the soil washes away and the slab loses support. Either scenario produces differential foundation movement, which manifests as sticking doors, diagonal wall cracks, and sloping floors. Foundation damage from an undetected slab leak is typically not covered by standard homeowners insurance as it is classified as ongoing neglect rather than a sudden event.

Slab leaks occur when a water supply or drain line embedded in a concrete foundation develops a breach. The three primary causes are: (1) soil movement — expansive clay soils shrink and swell seasonally, stressing pipe joints and bending copper lines over time; (2) pipe corrosion — copper pipes embedded in concrete are exposed to alkaline pH and mineral contact that accelerates pitting; (3) water hammer — repeated pressure surges from rapid valve closures create micro-fractures at elbows and fittings. In cities built on high-shrink-swell Vertisol clay (Houston, Dallas, the Texas Blackland Prairie), soil movement is the dominant cause. In older cities with original copper runs, corrosion-driven pinhole failure is most common.

PEX (cross-linked polyethylene) and copper are the two most common residential supply pipe materials used today. Key differences: (1) Flexibility — PEX is semi-rigid and can be routed around corners without fittings, reducing leak point count; copper is rigid and requires fittings at every bend, each of which is a potential failure point. (2) Freeze resistance — PEX expands under freezing and returns to shape on thaw, dramatically reducing freeze burst risk; copper does not expand and bursts when water freezes inside. (3) Corrosion resistance — PEX is immune to the electrochemical corrosion that causes copper pinholes; copper is susceptible to water chemistry attack. (4) Cost — PEX material is typically 25–40% cheaper than copper. (5) Lifespan — PEX has a projected 50+ year service life with limited field data beyond 25 years; copper has a demonstrated 50–70 year track record. (6) Heat tolerance — copper handles high-temperature water better; PEX has a maximum service temperature of 200°F.

The timing depends on your primary risk profile. For freeze-risk regions (Midwest, Northeast, Mountain): late fall (October–November) before the first hard freeze is ideal for identifying vulnerable pipe sections before they are stressed. For clay soil regions (Texas, Oklahoma, Kansas, Alabama): late summer or early fall, after peak soil desiccation has maximized stress on slab pipes. For irrigation-heavy regions: early spring before irrigation systems are activated, when damaged components from the previous season can be identified before they cause water loss all summer. For all regions: the best practical answer is as soon as you notice any indicator — water bill increase, discolored water, running water sounds, unexplained moisture. Waiting for a 'good time' often means waiting until the leak has grown.